Baby Lock Embellisher (EMB12-2) Manual - Manual (Page 2)

"IMPORTANT SAFETY INSTRUCTIONS"
When using the needle felting machine, basic safety precautions should always be followed,
Including the following.
"Read all instructions before using".
DANGER -
To reduce the risk of electric shock.
1. The needle felting machine should never be left unattended when plugged in.
Always unplug this needle felting machine from the electrical outlet immediately after
using and before cleaning.
2. Always unplug before replacing light bulb. Replace bulb with same type rated 15 watts/110
volts in 110V/120V area. (15 watts 230 volts in 220V/240V area).
WARNING -
To reduce the risk of burns, fire, electric shock, or injury to persons.
1. Do not allow to be used as a toy. Close attention is necessary when the felting machine is
used by or near children.
2. Use this needle felting machine only for its intended use as described in this manual.
Use only attachments recommended by the manufacturer as contained in this manual.
3. Never operate this felting machine if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or dropped into water. Return the needle felt-
ing machine to the nearest authorized Baby Lock retailer for examination, repair, electrical
or mechanical adjustment.
4. Never operate the needle felting machine with any air openings blocked. Keep ventilation
openings of the needle felting machine and foot controller free from the accumulation of
lint, dust, and loose cloth.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
8. To disconnect, turn the main switch to the symbol "O" position which represents off, then
remove plug from outlet.
9. Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord.
10. Keep fingers away from all moving parts. Special care is required around the felting
machine needles.