Baby Lock Embellisher (EMB12-2) Manual - Manual (Page 11)

8
5. Yarn Embellishing cont.
Yarn threader 5. Rotate the handwheel to bring the needle
bar to its highest position.
6. Raise the cloth presser lifter lever.
7. Insert yarn into the yarn port using the yarn
threader. (Fig. 4)
8. Pull the yarn from the bottom of the cloth
presser. (Fig. 5)
9. Place fabric under the cloth presser.
10. While embellishing with yarn, fabric may
be moved in all four directions. (Fig. 6)
11. Lower the cloth presser lifter lever.
ATTENTION: Since there is such a wide vari-
ety of yarns to select from use care when
using dense, fuzzy, or thick yarns. It is recom-
mended to test sew a sample using all yarns
before sewing on your project. Turn hand-
wheel several times to insure there is no
resistance with needle penetration. Yarn rec-
ommended for use in this machine should not
exceed 4mm (5/32 inches) in diameter. Yarn
needs to be able to slide freely within the yarn
port.
NOTE: If needle bar is not rotated to the high-
est position, the yarn will not go down through
the inside of the needle bar.
At the beginning of the yarn
embellishing, slightly pull the
end of the yarn.
Fig. 4
Fig. 5 Fig. 6