Baby Lock Aventura (BLMAV) Instruction and Reference Guide - Manual (Page 163)

Adjustments During the Embroidery Process
Embroidering E-23
EM
BRO
ID
ER
Y
E
If the bobbin runs out of thread
When the bobbin begins to run out of thread during
embroidering, the machine will stop and the message below
will appear. Press and follow the directions below to
rethread the lower threading. If very little sewing remains, you
can embroider approximately 10 final stitches without
rethreading the machine by pressing . The machine will
stop after sewing approximately 10 stitches.
a
Press .
→ After the thread is automatically cut, the carriage will
move.
b
Unlock the frame-securing lever and remove the
embroidery frame.
• Be careful not to apply strong force to the fabric at
this time. Otherwise, the fabric may loosen in the
frame.
c
Insert a wound bobbin into the machine. (see “Setting
the Bobbin” of “Basic operations”.)
d
Press .
e
Attach the embroidery frame.
f
To return to the area in the pattern where you stopped
sewing, follow steps
c through f in the next
section.
Adjustments During the Embroidery Process
Note
• Be careful not to bump the embroidery unit
carriage or the presser foot when removing or
attaching the embroidery frame. Otherwise, the
pattern will not embroider correctly.