Awind WIGA / WGA-510 User's Manual - Manual (Page 50)

50
Start IP: 192.168.100.11
End IP: 192.168.100.254
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.100.10
DNS Server: 192.168.100.10
< Wireless Setup>
♦
Wireless LAN: The default setting is “Enable”
♦
SSID: You can change the default SSID and the maximum Length is 32 bytes.
♦
SSID Broadcast: The default value is “Enable”
♦
Channel: You can set a fixed channel or allow auto selection. The “Auto”
selection means after power on WPS, it will scan all of wireless channels and
select one clear channel automatically.
♦
Encryption: you can select “Disable” or one of WEP/WPA PSK/WPA2 PSK.
♦
Key: If Encryption is enabled, you have to enter a key according to the
encryption mode you selected. (If the length of the key entered is not
sufficient or too long, a warning message will pop up.)
♦
Channel Bandwidth: select from 20M or Auto (20M/40M)
< AP Client>
♦
Connect to Existing AP: The default setting is “Disable”. If you choose
“Enable” you need to enter the existing AP SSID that you want to connect.
When you select “Enable” option, the following information needs to be
entered accordingly to the existing AP setting:
Encryption: Select “Disable” or one of WEP/WPA PSK/WPA2 PSK.
Key: If Encryption is enabled, you have to enter a key according to the
encryption mode you selected. (If the length of the key entered is not
sufficient or too long, a warning message will pop up.)
Note: The Encryption and Key information must be consistent to the exiting
AP configuration.
< Gatekeeper>
Gatekeeper is designed for ensuring the enterprise network security within WPS
box
♦
“All Block” can block Guest Users(through wireless) to access all office
network(LAN),
♦
“All Pass” can allow Guest Users(through wireless) to access all office
network