Avalon Firestyles Salish-1999 to 2000 - Manual (Page 15)

Installation
(for qualified installers only)
15
Travis Industries 9 3 5 0 8 1 0 7 1 0 0 2 0 1
6 Let the heater burn for fifteen minutes. Adjust the air shutter, if necessary, to achieve the correct
looking flame (see the illustration below).
¥ The air shutter adjusts
the amount of air that
mixes with the gas
before it exits the
burner holes. It is
used to fine-tune the
flame for differences in
altitude and vent
configuration.
NOTE: If the air control is all the way in, yet the flames
remain sooty, shut off gas to the fireplace and contact
a qualified gas service technician.
Correct
Flames should be blue at the
base, yellow-orange on the top.
If the flames are over 12" tall or sooty
on the ends, push the air control in.
If the flames are all blue and
short, pull the air control out.
Not Enough Air Too Much Air
NOTE: The logs must be installed correctly to
monitor the flame while adjusting the air shutter.
Loosen this screw two turns.
Slide the air shutter rod in or out.
IN = MORE AIR
OUT = LESS AIR
Tighten the nut to
secure the shutter.
a
b
c
3/8" Nutdriver
Swing the
left side
door open.
! If the vent configuration is installed incorrectly the vent may cause the flames inside the heater to lift or
ÒghostÓ Ð a dangerous situation. Inspect the flames after installation to insure proper performance. If
the vent configuration is correct, yet the flames are lifting or ghosting, shut off gas to the heater and
contact the dealer for information on remedying the problem.
The flames should burn right off
the top of the burner ports (if they
are too blue, adjust the air control). If the flames are lifting, yet the
vent configuration is correct,
contact your dealer.
Burner Tube
Burner Ports
(holes)
If the flames are ghosting, yet the
vent configuration is correct,
contact your dealer.
7 Turn the flame adjust knob to its highest position - the flames should be a maximum 10Ó to 12Ó tall.
Check the flame on low position. The flames should burn off of each burner hole. If the heater does
not work correctly, contact your dealer for a remedy.
8 Give this manual to the home owner and fully explain the operation of this heater.