Installation – Avalon Firestyles AGP Pellet User Manual

Page 12

Text mode
Original mode

Installation

(For Qualified Installers Only)

4141230

100-01341

Hopper Extension Setup

Remove the two shipping screws on each side of the insert (see illustration on previous page).

Remove the hopper top.

Use a center-punch to remove the appropriate knock-outs from the hopper walls (9 total). The
holes are punched out from the inside. Make sure to support the hopper walls while removing the
knock-outs. In the example below the “A” position is used (tallest hopper position).

Place the hopper top over the hopper assembly. Line up the holes in the hopper top with the
holes on the hopper assembly. Use the 9 screws included in the owner’s pack to secure the
hopper top to the hopper assembly.