Installation – Avalon Firestyles AGP Pellet User Manual

Page 10

Installation

(For Qualified Installers Only)

4141230

100-01341

Electrical Requirements

 This

heater

requires a standard 120 volt, 60 Hz grounded electrical outlet. Do not use an

adapter plug or sever the grounding plug.

 This

heater

requires correct polarity. The line (hot) is on the right and has a smaller plug. The

neutral (common) is on the left and has a larger plug. Use a circuit tester (available at hardware
stores) or contact an electrician to verify correct polarity and grounding.

WARNING: CONNECTION TO A REVERSE POLARITY OR UN-GROUNDED CIRCUIT MAY
DAMAGE YOUR HEATER’S CIRCUIT BOARD. THIS MAY CAUSE A SAFETY HAZARD,
IMPROPER OPERATION, AND VOID YOUR WARRANTY.

 Do not route the electrical cord underneath, in front of, or over the heater.

HINT: Travis Industries manufactures a Insert Wiring Kit (97200315) that allows the power cord to

be routed through the fireplace, concealing the power cord.