Avalon Firestyles 21 DV RV - Manual (Page 14)

14 Installation (for qualified installers only)
© Travis Industries 4060517 100-01158
Electrical Line Connection
a
b
Insert the sheathed cable from the power source through
this cable clamp. Once the wires are attached, tighten
the clamp to secure the cable.
Replace the
cover removed
in step "a".
Attach the common (white), ground (exposed or green)
wires, and hot (black) wires from the power source to the
electrical connector (attached to the fireplace).
c
d
Standard
Screwdriver
Remove the cover
from the fireplace
junction box.
1/4" Nutdriver
WARNING: Make sure power is
off from the power lead before
conducting any wiring.
Electrical
Connector
Optional Electrical Line Location
c
Remove the eight screws securing the
access plate and electrical inlet
assembly (save these screws).
a
1/4" Nutdriver
b
Remove the cover plate on the bottom
of the fireplace (save the nuts).
Position the electrical inlet assembly over the hole in
the baseplate of the fireplace and secure using the
screws removed in step “a”.
1/4" Nutdriver
d
5/16" Wrench
Attach the cover plate to the access plate using
the two nuts removed in step “b”. Attach the
access plate to the fireplace using the screws
removed in step “a”.
1/4" Nutdriver
Electrical Inlet
Assembly
Access Plate
5/16" Wrench
Cover Plate