Ez zone upgrade overview – Auto-Zone Control Systems EZ-Zone to Auto-Zone Upgrade Guide (Version 01C) User Manual
Page 5

EZ Zone/Auto-Zone
Upgrade
5
The basic steps required to upgrade your EZ
Zone system to an Auto-Zone system are:
z
Determine what EZ Zone components
are currently installed on the system.
z
Replace the existing EZ-Zone Master
Controller board with an Auto-Zone
Zone Manager controller board
z
Replace the existing EZ Zone
EPROM’s in each Zone Controller
with a new Auto-Zone EPROM.
z
Install return air and outside air
temperature sensors
EZ Zone to Auto-Zone upgrade allows you to
retain:
z
All existing wiring
z
Master Controller enclosure with
keypad and display
z
Existing supply air and static pressure
sensors
z
Existing bypass damper
z
All Zone Dampers
z
* All Zone Controllers
z
Room sensors
z
* Modem Link Central
z
* All Master Interface Boards
z
All Fan Terminal Controllers
EZ Zone Upgrade Overview
After upgrading your system from EZ Zone to
Auto-Zone, you will be able to take advantage
of many new enhancements including:
z
Damper actuators can be programmed
for direct or reverse operation
z
Full modulating economizer control
capability including optional wetbulb
economizer control
z
Outside air temperature sensor provides
lockout function for both heating and
cooling. When converted to Auto-Zone
Plus system only one outside air sensor
is required for the entire system
z
Contact closure input for dirty filter
status
z
Global and individual zone override
modes
z
Zones can be set for voting or
nonvoting status
z
Room sensor slide can be programmed
± 0° F to ± 5° F adjustment
from setpoint
z
Staging delays, minimum off times,
and changeover intervals are
programmable
z
Sensor offset calibration to correct
sensor errors due to poor location
z
ZoneView enhanced graphical computer
front end software available when
CommLink and a PC are used
z
System Manager operator interface
allows all controllers to be accessed from
one central location
*
These controllers can be retained but they will re-
quire an EPROM chip upgrade to be compatible
with the Auto-Zone System.