Artesyn ViewCheck on PrAMC-7311 Installation and Use (May 2014) User Manual
Viewcheck on pramc-7311
This manual is related to the following products:
- ViewCheck on ATCA-F140 Installation and Use (September 2014) ViewCheck on ATCA-7370 Installation and Use (November 2014) ViewCheck on PrAMC-7311 Installation and Use (November 2014) ViewCheck on ATCA-7470/7475 Installation and Use (September 2014) ViewCheck on ATCA-7470/7475 Installation and Use (November 2014) ViewCheck on PrAMC-7311 Installation and Use (September 2014) ViewCheck on ATCA-7470/7475 Installation and Use (May 2014) ViewCheck on ATCA-9405 Installation and Use (May 2014) ViewCheck on ATCA-F140 Installation and Use (November 2014) ViewCheck on ATCA-9405 Installation and Use (September 2014) ViewCheck on ATCA-7480 Installation and Use (April 2015) ViewCheck on ATCA-9405 Installation and Use (November 2014) ViewCheck on ATCA-7370 Installation and Use (April 2014) ViewCheck on ATCA-F140 Installation and Use (April 2014)
Table of contents
Document Outline
- ViewCheck on PrAMC-7311
- About this Manual
- Introduction
- Concepts of ViewCheck
- License Management
- Installation of ViewCheck
- Commands Execution
- 5.1 Overview
- 5.2 Generic Commands
- 5.2.1 configure-error-strings
- 5.2.2 configure-log-path
- 5.2.3 device-category
- 5.2.4 diag-service
- 5.2.5 hw-inventory-list
- 5.2.6 list-all-tests
- 5.2.7 list-device-instances
- 5.2.8 purge-all-log
- 5.2.9 purge-log
- 5.2.10 set-log-level
- 5.2.11 show-all-monitors
- 5.2.12 show-diag-scan-result
- 5.2.13 show-log-content
- 5.2.14 show-log-info
- 5.2.15 show-running-mode
- 5.2.16 show-systemerror-log
- 5.2.17 start-all-monitors
- 5.2.18 start-diag-scan
- 5.2.19 stop-all-monitors
- 5.2.20 stop-diag-scan
- 5.2.21 version
- 5.3 Test Management and Control Commands
- 5.4 Monitoring Commands
- 5.4.1 show-monitor-id
- 5.4.2 show-poll-interval
- 5.4.3 show-lower-threshold-info
- 5.4.4 show-upper-threshold-info
- 5.4.5 start-monitor
- 5.4.6 set-lower-threshold-info
- 5.4.7 set-upper-threshold-info
- 5.4.8 set-threshold-default
- 5.4.9 set-poll-interval
- 5.4.10 set-poll-interval-default
- 5.4.11 stop-monitor
- 5.4.12 set-rate
- 5.4.13 show-rate
- 5.4.14 show-networkcounter-log
- 5.4.15 show-networkerror-log
- 5.4.16 exit
- 5.5 InService Monitoring Specifics
- 5.6 OOSD Tests
- A Related Documentation