7 set-upper-threshold-info, Commands execution – Artesyn ViewCheck on PrAMC-7311 Installation and Use (May 2014) User Manual
Page 76
Commands Execution
ViewCheck on PrAMC-7311 Installation and Use (6806800S45C)
76
5.4.7
set-upper-threshold-info
set-upper-threshold-info
command is used to set the upper threshold value for a
particular monitor based on which the monitor performs.
Syntax for CLI
set-upper-threshold-info monitorId < Monitor ID> deviceInstance
Syntax for XML
Dev Instance
Enum
Use list-device-instances CLI command to get the
equivalent enumerated value of supported Device
Instance
Threshold
Value
Integer
Type a threshold value for the specified monitor ID
Table 5-20 set-lower-threshold-info
Argument
Data Type
Description
This manual is related to the following products:
- ViewCheck on ATCA-F140 Installation and Use (September 2014) ViewCheck on ATCA-7370 Installation and Use (November 2014) ViewCheck on PrAMC-7311 Installation and Use (November 2014) ViewCheck on ATCA-7470/7475 Installation and Use (September 2014) ViewCheck on ATCA-7470/7475 Installation and Use (November 2014) ViewCheck on PrAMC-7311 Installation and Use (September 2014) ViewCheck on ATCA-7470/7475 Installation and Use (May 2014) ViewCheck on ATCA-9405 Installation and Use (May 2014) ViewCheck on ATCA-F140 Installation and Use (November 2014) ViewCheck on ATCA-9405 Installation and Use (September 2014) ViewCheck on ATCA-7480 Installation and Use (April 2015) ViewCheck on ATCA-9405 Installation and Use (November 2014) ViewCheck on ATCA-7370 Installation and Use (April 2014) ViewCheck on ATCA-F140 Installation and Use (April 2014)