Artesyn ViewCheck on PrAMC-7311 Installation and Use (May 2014) - Manual (Page 89)

Commands Execution
ViewCheck on PrAMC-7311 Installation and Use (6806800S45C) 89
5.6.7 NETWORK
 EthLinkTest: Verifies Ethernet device (ex: eth0, eth1, eth2, etc...) link status
(active/inactive) and also captures various statistics of Ethernet device.
 FloodPingTest: FloodPingTest uses the ICMP protocol’s mandatory ECHO_REQUEST
datagram to elicit an ICMP_ECHO_RESPONSE from a host or gateway. ECHO_REQUEST
datagram’s have an IP and ICMP header, followed by a structure timeval and then an
arbitrary number of ’Pad’ bytes used to fill out the packet.
 EthStatsTest: Tests basic network packet consistency that is checks network Rx, Tx errors,
generates a warning if errors are less than or equal to 100 and marks the test as fail if
number of errors are more than 100.
 NetworkCntlrTest: Verifies random data transmitted and also the data received for each
configured network device. It verifies only Ethernet and token ring devices that are
configured and active. The asynchronous devices are not verified.
 NetworkAdapterTest: Test executes adapter selftest (BIST) on the specified ethernet
device.
5.6.8 USB
 USBScanTest: This test scans for on-board USB devices and lists any newly added USB
devices.
 USBReadTest: This test does repeated accesses to USB partition, reads and verifies the
data.
For FloodPingTest and NetworkAdapterTest, make sure that Ethernet interfaces
eth0-4 are all configured appropriately.