9 set-poll-interval, Table 5-22, Set-threshold-default – Artesyn ViewCheck on PrAMC-7311 Installation and Use (May 2014) User Manual
Page 78: Commands execution

Commands Execution
ViewCheck on PrAMC-7311 Installation and Use (6806800S45C)
78
]]>]]>
The following table provides the set-threshold-default command arguments.
5.4.9
set-poll-interval
set-poll-interval
command is used to set the Poll interval value for monitors.
Syntax for CLI Instance> pollInterval Syntax for XML Table 5-22 set-threshold-default Argument Data Type Description Monitor ID Integer Type the unique ID of the Monitor for which you want to Dev Instance Enum Use list-device-instances CLI command to get the
set-poll-interval monitorId
reset its threshold value to default value
equivalent enumerated value of supported Device
Instance
This manual is related to the following products:
- ViewCheck on ATCA-F140 Installation and Use (September 2014) ViewCheck on ATCA-7370 Installation and Use (November 2014) ViewCheck on PrAMC-7311 Installation and Use (November 2014) ViewCheck on ATCA-7470/7475 Installation and Use (September 2014) ViewCheck on ATCA-7470/7475 Installation and Use (November 2014) ViewCheck on PrAMC-7311 Installation and Use (September 2014) ViewCheck on ATCA-7470/7475 Installation and Use (May 2014) ViewCheck on ATCA-9405 Installation and Use (May 2014) ViewCheck on ATCA-F140 Installation and Use (November 2014) ViewCheck on ATCA-9405 Installation and Use (September 2014) ViewCheck on ATCA-7480 Installation and Use (April 2015) ViewCheck on ATCA-9405 Installation and Use (November 2014) ViewCheck on ATCA-7370 Installation and Use (April 2014) ViewCheck on ATCA-F140 Installation and Use (April 2014)