Artesyn ViewCheck on ATCA-9405 Installation and Use (September 2014) - Manual (Page 80)

Commands Execution
ViewCheck on ATCA-9405 Installation and Use (6806800S51E) 80
4.5.2 Monitoring Device Critical Errors
Under Linux OS, the Device Drivers LOG abnormal behavior and potential errors occurring in
the Hardware device with KERN_ERR or KERN_CRIT category. These notifications are
considered as potential errors as they could manifest into latent faults in the live system.
As part of monitoring the Device Critical errors, all such Kernel CRITICAL and Kernel ERROR
notifications have been extracted from the PNE Kernel (4.1) driver sources and represented in
the form of a database.
The In Service Monitoring Module of ViewCheck would watch out for the occurrence of these
notifications and on detection would send a notification to XML.
The Device Errors are captured and are identified uniquely by ERROR ID. For definition of
ERROR ID, refer
Error ID on page 19 .
4.6 OOSD Tests
OOSD Tests are used to monitor and manage the performance of the hardware components of
blades. You can execute these tests only when blades are offline, that is blades are not
providing any service. Details of the test is supported on SP or PP or both is mentioned with the
test name.
Network Counters 1021 eth0(62),eth1(63),eth2(
64) Monitors the various counters for
each of the Network Device
Instances
Table 4-24 Monitors (continued)
Monitor Description
Monitor
ID
Valid Device Instances Remarks
Before starting any PP related OOSD diagnostics test, make sure that VLAN interface
(example, eth1.21) reaching octeon is properly configured with an IP.