Artesyn ViewCheck on ATCA-9405 Installation and Use (September 2014) - Manual (Page 26)

Installation of ViewCheck
ViewCheck on ATCA-9405 Installation and Use (6806800S51E) 26
Installing the ViewCheck Service OS image on SP
Before installing the ViewCheck service OS Image, you should have the knowledge of
configuring TFTP Server, configuring ATCA-9405 for Network Booting and Booting ATCA-9405
using a ramdisk. For more information, refer to the section 2.3 in Blade Services Software on
ATCA-9405 PR guide.
1. Once the blade is configured to boot with ramdisk image, it will have ViewCheck
and Blade Services Framework installed.
2. SP should also have the interfaces to PP1 and PP2 configured so that a
communication can be established between SP and PP's.
Installing the ViewCheck Service OS image on PP
The following procedure is to boot the ViewCheck OOS image on PP. For more information,
refer to section 2.6.5 in Blade Services Software on ATCA-9405 Programmer’s Reference Guide.
1. On SP, go to /opt/diagnostics/etc/diag/ location and execute the
runlinux scripts.

For installing ViewCheck Service OS image on PP1, execute ./runlinux 1
command.

For installing ViewCheck Service OS image on PP2, execute ./runlinux 2
command.
Installing ViewCheck Service OS Image on USB
The ViewCheck service OS image can be installed on any external USB drive using flashprep
and flashinstall tools available on the board.
Use the flashrc tool available on the board to install the ViewCheck service OS image on USB
device.
Before installing ViewCheck Service OS image on PP, make sure that vlans are configured
appropriately to reach Octeons.