Artesyn ViewCheck on ATCA-9405 Installation and Use (May 2014) - Manual (Page 43)

Installation of ViewCheck
ViewCheck on ATCA-9405 Installation and Use (6806800S51D) 43
BSF(diag-SP_VEE0-networkinterface)#start-monitor monitorId 1020
deviceInstance 63
MONITOR IS STARTED
To exit from the ViewCheck CLI:
BSF(diag-SP_VEE0)#exit
BSF(VEE-vee0)#exit
BSF(config)#exit
#exit
4.6 Access and Execution of a Test Using XML
You can access ViewCheck XML interface similar to ViewCheck CLI.
1. Establish the secure shell using SSH or Putty.
2. Start the Telnet connection from an already established secure shell.
telnet localhost 15550
Trying 127.0.0.1...
Connected to localhost.localdomain (127.0.0.1).
Escape character is '^]'.
4.6.1 Authenticate
After a connection with the XML Agent is established, the only command which should be
executed is Authenticate. This command is for evaluating user credentials.
The Authentication command contains user name and password for verification. Successful
authentication is indicated by the success response, otherwise an error message is returned.