Artesyn ViewCheck on ATCA-7370 Installation and Use (April 2014) - Manual (Page 82)

Commands Execution
ViewCheck on ATCA-7370 Installation and Use (6806800S48B) 82
5.6.7 NETWORK
 EthLinkTest: Verifies Ethernet device (ex: base0,base1,fabric0,fabric1,etc...) link status
(active/inactive) and also captures various statistics of Ethernet device.
 FloodPingTest: FloodPingTest uses the ICMP protocol’s mandatory ECHO_REQUEST
datagram to elicit an ICMP_ECHO_RESPONSE from a host or gateway. ECHO_REQUEST
datagram’s have an IP and ICMP header, followed by a structure timeval and then an
arbitrary number of ’Pad’ bytes used to fill out the packet.
 EthStatsTest: Tests basic network packet consistency that is checks network Rx, Tx errors,
generates a warning if errors are less than or equal to 100 and marks the test as fail if
number of errors are more than 100.
 NetworkCntlrTest: Verifies random data transmitted and also the data received for each
configured network device. It verifies only Ethernet and token ring devices that are
configured and active. The asynchronous devices are not verified.
 NetworkAdapterTest: Test executes adapter selftest (BIST) on the specified ethernet
device.
5.6.8 FPGA
 FpgaRegRdTest: This test Read/write FPGA resisters and also checks for the default register
values.
5.6.9 I2C
 I2cDetectionTest (SP): This test modprobes an i2c module and checks for default i2c
devices on board.
5.6.10 USB
 UsbReadTest: This test does repeated accesses to usb partition, reads and verifies the data.