Artesyn ViewCheck on ATCA-7370 Installation and Use (April 2014) - Manual (Page 32)

Installation of ViewCheck
ViewCheck on ATCA-7370 Installation and Use (6806800S48B) 32
#destination
destination diag_pipe { pipe(/opt/diagnostics/var/log/diagpipe);
};#filter
filter f_crit { level(err..crit); };#Log path
log { source(s_sys); filter(f_crit); destination(diag_pipe); };
4.3 BSF Service RPM
BSF service is distributed as 3 RPM packages namely eMIND, BSFCore and Diagnostics
Transport layer service. Following are the list of RPM:
ssf_main_rel---..rpm
ssf_csim_rel---..rpm
ssf_diagnosticsTLS_rel---..rpm
You should install BSF RPMs in the following sequence:
1. ssf_main
2. ssf_csim
3. ssf_diagnosticsTLS
You can install the BSF using the following RPM commands:
 rpm -iv --nodeps --force ssf_main_rel---
..rpm
 rpm -iv --nodeps --force ssf_csim_rel---
..rpm
 rpm -iv --nodeps --force ssf_diagnosticsTLS_rel---
..rpm
So even if user modifies the syslog.conf, these entries should not be removed, else it would
impact the inService functionality of diagcore daemon.