Artesyn ViewCheck on ATCA-7370 Installation and Use (April 2014) - Manual (Page 51)

Chapter 5
ViewCheck on ATCA-7370 Installation and Use (6806800S48B) 51
Commands Execution
5.1 Overview
CLI and XML are the primary ways to access ViewCheck capabilities on the blade. These
mechanisms allows you to perform activities such as start, stop and query on the ViewCheck
software. Using CLI and XML you can also set the parameters for monitoring.
Commands are classified into:
 Generic commands
 Commands for test management and control
 Commands for monitoring
5.2 Generic Commands
Following are the general functional commands provided by the ViewCheck service.
5.2.1 device-category
device-category
command allows to configure the available device categories.
Syntax
device-category
Expected Output
The CLI prompt will show the device category that you have selected
.
The command syntaxes for XML interface is given for the diagnostic class with instance as
vee0. This instance varies depending on the blade.
This command is valid only in CLI.