DVS -30-2 - Manual (Page 49)

13369-1-0203 Page 49
INDEX PART DESCRIPTION QUANTITY
NUMBER NUMBER SUPPLIED
1 11935 BLOWER DIVERTOR 1
2 R-6458 CORD SET 1
3 10758 FAN CONTROL BRACKET 1
4 R-2503 FAN CONTROL 1
5 R-6459 WIRE HARNESS 1
6 11932 BLOWER SUPPORT 1
7 R-6460 BLOWER ASSEMBLY 1
8 11933 SWITCH BRACKET 1
9 R-6461 SWITCH 1
NS 10146 BLOWER GASKET 2
NS R-1720 CABLE CLIP 1
NS R-1499 GROMMETS 3
NS R-1454 BUSHING 3
PARTS LIST
Figure 3
Wiring
The appliance, when installed, must be electrically grounded in accor-
dance with local codes or, in the absence of local codes, with the National
Electrical Code ANSI/NFPA No. 70, if an external electrical source is
utilized. This appliance is equipped with a three-prong [grounding]
plug for your protection against shock hazard and should be plugged
directly into a properly grounded three-prong receptacle. Do not cut
or remove the grounding prong from this plug. For an ungrounded
receptacle, an adapter, which has two prongs and a wire for grounding,
can be purchased, plugged into the ungrounded receptacle and its wire
connected to the receptacle mounting screw. With this wire completing
the ground, the appliance cord plug can be plugged into the adapter and
be electrically grounded.
CAUTION: Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
Blower Motor
The blower motor does not have oiling holes. Do not attempt to oil the
blower motor.
Blower Wheels
The blower wheels will collect lint and could require periodic cleaning.
If the air output decreases or the noise level increases, it indicates a dirty
blower wheel. Remove blower and clean blower wheels.
WARNING:
Unplugging of blower accessory will not stop the heater from
cycling. To turn off gas to the unvented heater: Push in gas
control knob slightly and turn clockwise to “OFF.” Do not force.