Artesyn RTM-ATCA-F120 Installation and Use (August 2014) - Manual (Page 21)

Chapter 1
RTM-ATCA-F120-OPT Installation and Use (6806800G29D) 21
Introduction
1.1 Features
The RTM-ATCA-F120-OPT is a rear transition module (RTM) as defined in the PICMG 3.0
revision 2.0 AdvancedTCA Base Specification for AdvancedTCA systems. It is designed to be
used with the ATCA-F120 base blade and provides the following I/O interfaces towards the
back of the ATCA-F120:
 Four 10 Gigabit Ethernet Fabric Channel uplinks via SFP+ connectors
 Two 10 Gigabit Ethernet Base Channel uplinks via SFP+ connectors
 Four 1 Gigabit Ethernet Base Channel interfaces via SFP connectors
 Two 1 Gigabit Ethernet Fabric Channel interfaces via SFP connectors
 Two RJ-45 telecom clocking interface connectors for inter-shelf clocking configurations
 One serial RS-232 interface for accessing the base blade
 On-board mezzanine management controller (MMC) compliant to IPMI 2.0