Artesyn MVME55006E Single Board Computer Installation and Use (July 2014) - Manual (Page 83)

Chapter 5
MVME55006E Single Board Computer Installation and Use (6806800A37J) 83
Connector Pin Assignments
5.1 Introduction
This chapter provides pin assignments for various headers and connectors on the MMVE5500
single-board computer.
 Asynchronous Serial Port Connector (J1) on page 84
 Ethernet Connectors (J2) on page 84
 IPMC Connector (J3) on page 85
 PCI/PMC Expansion Connector (J4) on page 87
 CPU COP Connector (J5) on page 89
 PMC 1 Interface Connectors (J11, J12, J13, J14) on page 90
 Boundary Scan Connector (J18) on page 95
 PMC 2 Interface Connectors (J21, J22, J23, J24) on page 96
 Asynchronous Serial Port (COM2) Planar Connector (J33) on page 101
 VMEbus Connectors (P1 & P2) (PMC Mode) on page 102
 VMEbus Connectors (P1 & P2) (SBC Mode) on page 104
 Memory Expansion Connector (P4) on page 107
The following headers are described in this chapter:
 Ethernet 2, PMC/SBC Mode, and P2 I/O Selection Headers (J6, J7, J28, J32, J34, J97 – J110) on
page 110
 Flash Boot Bank Select Header (J8) on page 117
 VME SCON Select Header (J27) on page 117
5.2 Connectors
This section discusses the various connectors on the MVME5500.