Artesyn MVME55006E Single Board Computer Installation and Use (July 2014) - Manual (Page 44)

Hardware Preparation and Installation
MVME55006E Single Board Computer Installation and Use (6806800A37J) 44
4. Ensure that the levers of the two injector/ejectors are in the outward position.
5. Slide the MVME5500 into the chassis until resistance is felt.
6. Simultaneously move the injector/ejector levers in an inward direction.
7. Verify that the MVME5500 is properly seated and secure it to the chassis using the
two screws located adjacent to the injector/ejector levers.
8. Connect the appropriate cables to the MVME5500.
1.10.1 Connection to Peripherals
When the MVME5500 is installed in a chassis, you are ready to connect peripherals and apply
power to the board.
Figure 1-2 on page 26 shows the locations of the various connectors while Table 1-3 lists them
for you. Refer to Chapter 5, Connector Pin Assignments for the pin assignments of the
connectors listed below.
Figure 1-18 Installation into a Typical VME Chassis