Argox AR-3000 Scan Utility - Manual (Page 23)

23
Truncate leading/ending: The leading or ending digits of barcode data characters can be truncated when these
values are set to non-zero. This will beep
instead of reading anything when the truncate value is more than the
barcode data digits or the value of Truncate Leading overlaps with that of the Ending. The maximum value of the
truncate digits is 15.
.
Code ID setting: Code ID setting is a character used to represent the symbol upon a succeeding reading. This sets
the position of the Code ID for before or after code data for transmission.
Insertion group selection: The scanner offers one or two insertion groups for its own symbology. Set one or two
digits to indicate which insertion group you want to insert. You may refer to Character insertion. Set from 0 to 4 for
this function.
Format: The Full ASCII Code-39 is an enhanced set of Code-39 that is data with a total of 128 characters to
represent the Full ASCII code. It combines one of the digits +, %, $ and/ with one of the alpha digits (A to Z).
Append: This function allows several symbols to be concatenates and treated as one single data entry. The
scanner will not transmit the embedded appending code (space for Code-39). If Enable and other symbols were
read again with the appended code, then codes are transmitted without Code ID, Preamble and Prefix. When a
symbol is decoded without the appended code, the data is transmitted without Code ID and Prefix, but the
Postamble Suffix codes are appended. This function is used when the first number of code 39 is a space.
Start/end transmission: The start and end characters of Code-39 are “★”. You can transmit all data digits including
two “★”.