Aplex Technology ACS-2210A - Manual (Page 12)

ACS-2210A User Manual 12
Note:
Make sure that the voltage of power supply is DC9V~32V before power on, or it
may cause boot up failure and even system damage.
3. BAT1:
(1.25mm Pitch 1X2 box Pin Header) 3.0V Li battery is embedded to
provide power for CMOS.
Pin#
Signal
Name
Pin1 VBAT
Pin2 Ground
4. USB67:
(2.0mm Pitch 2x5 Pin Header) ,Front USB connector, it provides two
USB ports via a dedicated USB cable, speed up to 480Mb/s.
USB6 and USB7 can only be used for internal device attachment as USB 2.0 SpecIfi-
cation, Can not support USB1.1 and USB 1.0 Specification.
Signal Name Pin# Pin# Signal Name
+5V 1 2 +5V
USB6_N 3 4 USB7_N
USB6_P 5 6 USB7_P
Ground 7 8 Ground
NC 9 10 Ground
Note:
Before connection, make sure that pin out of the USB Cable is in accordance with
that of the said tables. Any inconformity may cause system down and even hardware
damages.
5. USB23/USB45
: (Double stack USB type A), Rear USB connector, it provides
up to 4
USB2.0 ports, speed up to 480Mb/s. USB2 support USB client function, BIOS setting:
USB Client Controller [Enabled].
Turn off the power before removing USB2 cable, otherwise it will burn ASB-B705 .