Analog Way Universal Booster - UB813 - Manual (Page 5)

UNIVERSAL BOOSTER™
PAGE 5
ENGLISH
UNIVERSAL BOOSTER ™ (UB813)
Chapter 1 : INTRODUCTION
1-1. SUPPLIED EQUIPMENT
• 1 UNIVERSAL BOOSTER ™ (UB813)
• 1 AC Power Supply Cord.
1-2. GENERAL INFORMATION
The UNIVERSAL BOOSTER ™ is a multiway - 8 x {1 Input to a 3 way Output} - distribution amplifier for RGBHV,
RGB/S, RGsB, YUV, Computer, Video & HDTV signals.
Each of the 8 independent inputs can be split into 3 separately buffered outputs. It is the equivalent of integrating in the
same enclosure, 8 different booster boxes of 1 to 3 outputs each. In other words, it saves space, cost and power
consumption.
The Universal Booster ™ offers a 300 MHz bandwidth for signal transparency.
The UNIVERSAL BOOSTER ™ virtually splits and boosts any Computer, HDTV and SDTV sources such as PC,
MAC  , laptop, any workstation, line doubler, scaler, video presenter, video & industrial camera, VCR, DVD, laser
disc.
1-3. INSTALLATION
IMPORTANT: Please read all of the safety instructions (page 2 to 4) before starting.
• Table top mounting: The UNIVERSAL BOOSTER ™ can also be used directly on a table. The unit is delivered with 4
plastic feet.
• Rack mounting: The UNIVERSAL BOOSTER ™ is compatible with a 19” enclosure. Please follow the
instructions below to install the UNIVERSAL BOOSTER ™ in a 19” rack.
c Place the UNIVERSAL BOOSTER ™ in your rack.
NOTE: Your rack must be equipped with some braces.
d Attach the UNIVERSAL BOOSTER ™ to the rack by using 4 screws in the front panel holes
(screws are not included).
e Connect all of the cables of the UNIVERSAL BOOSTER ™ and attach them to the rack with
some tie wraps.
IMPORTANT: - Be sure that no weight in excess of 2 kg (4.4 Lbs.) is added onto the UNIVERSAL
BOOSTER ™ .
- The maximum ambient operating temperature must not exceed 40 °C (104 °F).
- The rack and all mounted equipment in it must be reliably grounded to national and local
electrical codes.