AMETEK MX Series Installation Manual - Manual (Page 22)

Installation Manual - Rev D California Instruments
MX Series 18
2.6.5 MX90 Output Wiring Diagram
Figure 2-9 shows the required output connections for a MX90-3 three phase output configuration (rear-view perspective). Always
disconnect all input power from the MX90 before removing the front panel cover that provides access to the input and output terminal
connections. Route the wires from the back of the MX45 chassis to the front in the provided cable guides. MX90 and MX135 systems are
shipped with external output terminal blocks that enable the output wiring from two or three chassis to be combined, providing a single
point of connection to the EUT. These blocks are not enclosed however.
Figure 2-9: MX90 or MX90-MB Output Wiring