AMETEK MX Series Installation Manual - Manual (Page 20)

Installation Manual - Rev D California Instruments
MX Series 16
2.6.3 MX45-1 and MX45-3Pi 1 ø mode Output Wiring Diagram
Figure 2-7 shows the required output connections for a MX45-1 or MX45-3Pi in single phase
mode output configuration (rear-view perspective). See section 2.6.4 for the MX45-3Pi in three-
phase mode.
Always disconnect all input power from the MX45 before removing the front panel cover that
provides access to the input and output terminal connections. Route the wires from the back of
the MX45 to the front in the provided cable guides.
Figure 2-7: MX45-1 Output Wiring