AMETEK CW Series Programming Manual - Manual (Page 8)

Programming Manual 2-1
SECTION 2
POWER-ON AND RESET CONDITIONS
The following sections define the factory and reset power-on conditions of the unit.
2.1 Factory Defaults
When the CW-P unit is first powered up, the following factory defaults will be in place:
GPIB Address: 25
RS-232 Baud Rate: 9600
RS-232 Data Bits: 8
RS-232 Stop Bits: 1
RS-232 Parity: N
2.2 Power-On Conditions
When the CW-P unit is first powered up, the system reads in the configuration that was
last saved to memory position 0. The specific system items in Save and Recall are:
VoltsA, VoltsB, VoltsC (B and C for multi-unit configuration)
Voltage Range, either High or Low
Current Protection Type, either Fold or Shut
Current Shutdown Time
Current LimitA, Current LimitB, Current LimitC (B and C for multi-unit configuration)
Frequency
Phase AngleAB
Phase AngleAC
External Input Assignment, either Analog In or Pulse Out.