AMETEK CW Series Programming Manual - Manual (Page 13)

SCPI Commands Elgar CW-P Series
3-4 Programming Manual
3.5 STATUS Commands
:STATus
The status commands tree.
:OPERation? SCPI commands returns „1‟.
:OPERation
The SCPI Operation sub-tree.
:[EVENt?] Returns „1‟.
:CONDition? Returns „1‟.
:ENABle
Sets the value in the Operations Enable register.
:ENABle?
Returns the value in the Operations Enable register.
:PRESet
Set the value of the Operations Enable register.
:QUEStionable? Returns „1‟.
:QUEStionable
:CONDition? Returns „1‟.
[:EVENt?] Returns „1‟.
:ENABle
Set the value of the Operations Enable register.
:ENABle?
Returns the value of the Operations Enable register.
3.6 SYSTEM Commands
:SYSTem
The system command tree.
:KLOCK? Returns „1‟ if the front panel programmable
keys are locked out.
:KLOCK „1‟ locks the front panel programmable keys.
:CHECKSUM?
Returns the results of the checksum test.
1 = the checksum passed, 0 = failed.
:CHECKSUM
Specify that the CW shall re-check its flash
checksum.
:COMMunicate
The communications sub-tree.
:GPIB
The GPIB communications channel.
[:SELF]
SCPI sub-command.
:ADDRess []
Set the GPIB address to a value of 1..31.
:ADDRess?
Returns the GPIB address presently set.
:AUTORUN „1‟ (ON) specifies the CW will automatically
close the output relay at power-
up. „0‟ (OFF)
specifies the CW will power up in standby.
:AUTORUN?
Returns the state of the autorun parameter,
either „0‟ or „1.‟
:STORe
Specify that the present system setpoint/
register set shall be saved to EEPROM at the
address. shall be 0..98.