Zilog Z8FS021A - Manual (Page 15)

UM023302-1214 11
ZMOTION ® Intrusion Detection Development Kit
User Manual
open grey area below the menu icons and select
Workbook Mode
to turn on the tabs at
the bottom of the editor and therefore make it easier to switch between files.
3. Click the
Rebuild All
icon to build the project. The build output should not indicate any
errors. If you receive errors, try reloading the projects from the original Application CD
and ensure that the folders are not set to
Read Only
. See Figure 4 for an example;
Figure 5 indicates the location of the
Rebuild All
icon in the ZDS II menu bar.
4. Make sure that the ZMOTION Development Board is powered OFF, then connect the
USB SmartCable (Debugger) to P2, as described above.
5. Apply power to the Development Board by plugging in the USB cable and setting SW1
to the ON position. Next, click the
Reset
icon in ZDS II. Figure 6 indicates the location
of both the
Reset
and
Go
icons in the ZDS II menu bar.
Figure 4. Building the ZMOTION_Intrusion_Demo project in ZDS II
Figure 5. The Location of the Rebuild All Icon
The Rebuild All icon