Zilog Z80195 - Manual (Page 31)

Z80185/195 D EVELOPMENT K IT
U SER ' S M ANUAL
3-11 UM951800100
Z ILOG
Change Serial Data Rate [N]
Changes the bit rate of serial communications between the host and the board. This command and
the L command are the two commands that require that you use the TZ.EXE program on a PC as the
terminal. These values are OSC dependent.
Caution: Do not change the oscillator on board.
Example:
Z80185>Enter 0 for 1200 Bits/Second
1 for 2400
2 for 4800
3 for 9600
4 for 14400
5 for 19600
6 for 28800
7 for 38400
8 for 57600
Enter 9 for 115200 bits/second: 9
Z80185>
Output Byte to I/O Address [O]
This performs an 8-bit output to a 16-bit I/O address.
Example:
Z80185>Output to I/O Address : c3
Data: 00
Z80185>