Zilog Z80195 - Manual (Page 22)

Z80185/195 D EVELOPMENT K IT
U SER ' S M ANUAL
3-2 UM951800100
Z ILOG
GETTING STARTED
Starting Up the TZ Program
(in DOS or at DOS Prompt in Windows)
Note: Proper installation of the monitor program assumes that the proper hardware setup is complete.
Before loading the monitor program, refer to "Chapter 2: Setup and Installation" for the complete
procedure for hardware setup, including setting up jumpers, connecting cables, and applying power
to the Z80185/195 Development Board.
1. Ensure that the PC is powered up and is functioning properly.
2. Verify that all jumper settings and cable connections are correct.
3. If using a PC, load the Z80185 Source diskette and copy the TZ.EXE program to the PC.
4. Enter "TZ com
n " (where n is the COM serial port number [1–4] of choice); press .
5. Connect the power supply cable to the 185/195 board.
6. Apply power through connector P1 on the 185/195 board.
7. Press the RESET button (S1).
Starting Up the TZ Program
(TZ Icon in Windows)
Note: Proper installation of the monitor program assumes that the proper hardware setup is complete.
Before loading the monitor program, refer to "Chapter 2: Setup and Installation" for the complete
procedure for hardware setup, including setting up jumpers, connecting cables, and applying power
to the Z80185/195 Development Board.
1. Ensure that the PC is powered up and is functioning properly.
2. Verify that all jumper settings and cable connections are correct.
3. Double-click on the TZ icon (specifying one of the COM serial ports).
4. Connect the power supply cable to the 185/195 board.
5. Apply power through connector P1 on the 185/195 board.
6. Press the RESET button (S1).
Opening Screen Message
If all connections to your PC are correct, you should see the following opening message at power up
or by pressing the RESET button on the board:
Zilog Z80185 Monitor Version v.m 1
Z80185 >
1 Where v is the current version of the debug monitor and m is the revision.
Exiting the TZ Program
If the TZ Program was started with DOS, type Control–C. TZ will return you to the DOS prompt.
If the TZ Program was started in Windows by double-clicking the TZ icon, the window will close or the
full-screen display will be replaced by the Windows environment.