Zilog EZ80190 User Manual
Page 8

ZDI232ZPAK2ZPK
ZiLOG ZPAK II Debug Interface Module
Page 8
UM016301-1003
Configure the Hardware
created buffer Pool 1524 32
created buffer Pool 4096 8
IP Address: 192.168.1.50
IP Subnet: 192.168.1.0/255.255.255.0
IP Gateway: 192.168.1.254
netstart exiting, stack extent 379/2048
ZPAKII version y.y
Copyright © 2001-2002 ZiLOG, Inc.
All Rights Reserved.
ZPAKII Console version 1.5
Type 'H' for help
ZPAKII:>
In the example output above,
x.x.x
denotes the current version of the TCP/IP
stack software, and
y.y
denotes the current version of ZPAK II. The console
prompt is not case-sensitive.
7. At the
ZPAKII
prompt, enter
H
and press ENTER. The following message should
appear:
ZPAKII:> H
H display this Help
I change Ipaddress
S change ipSubnet mask
G change ipGateway
P change Portnumber
V change dtli Variable count
B change dtli Buffer size
F load deFault settings
C display Current settings
A toggle pAssword
D toggle Dhcp option
W change passWord
R Reset zpakii
ZPAKII:>
8. Use the
I
command to change the ZPAK II’s IP address to one that is compatible with
the PC. Use caution to avoid creating a conflicting IP address.
9. Use the
S
command to change the ZPAK II’s subnet mask to one that is compatible
with the PC. Typically, the subnet mask is the same as that of the PC.
Note: