Zilog EZ80190 - Manual (Page 6)

ZDI232ZPAK2ZPK
ZiLOG ZPAK II Debug Interface Module
Page 6
UM016301-1003 Configure the Hardware
4. In the panel labeled This connection uses the following items:, select the Internet
Protocol (TCP/IP) item to highlight it, and click the Properties button (Figure 5).
The Internet Protocol (TCP/IP) Properties dialog box appears (Figure 6).
5. Enter values for the IP address and subnet mask to match those shown in Figure 6.
Leave any remaining fields blank. In this example, an IP address of 192.168.1.21 and
a subnet mask of 255.255.255.0 are being assigned to the PC. These values place the
PC on the same network as the ZPAK II unit, and do not conflict with the IP address of
ZPAK II.
6. Click OK and restart the PC.
7. The PC is now ready to communicate with the ZPAK II module.
8. The default IP address of the ZPAK II module is 192.168.1.50 . If this address con-
flicts with another address on the LAN, or if another address is more compatible, pro-
ceed to "Changing ZPAK II Module Settings to Match the PC" on page 7.
Figure 6. The Internet Protocol Properties Dialog