Appendix c. tera term configuration – Zilog Z8F1681 User Manual
Page 49
UM026301-1013
Tera Term Configuration
Z8 Encore! XP
®
F6482 Series Development Kit
User Manual
39
Appendix C. Tera Term Configuration
If you are using Tera Term as your console program, observe the following procedure to
properly configure it.
1. Connect the RS-232 to 6-pin circuit adapter to Jumper J20 on the F6482 Development
Board. At P1, connect the serial cable or USB-to-serial adapter, then connect the other
end to your PC.
2. In Tera Term, and if your PC has a serial interface, navigate via the
Setup
menu to
Serial port…
to select the COM port assigned to your serial port. If you do not have a
serial port on your PC, use a USB-to-serial adapter (not included in the kit).
3. Use the Ports (COM & LPT) listing in the Device Manager to determine the correct
COM port assigned to your adapter. Configure this port to reflect the following set-
tings:
–
57600 bps
–
8 data bits
–
No parity
–
1 stop bit
–
No flow control
4. Click the
OK
button to connect to the F6482 Development Board. Upon connection,
you should be able to see the demonstration program menu shown in