Hyperterminal configuration, In the – Zilog Z8F1681 User Manual
Page 22
The Z8 Encore! XP
®
F6482 Series Development Kit
UM026301-1013
12
Z8 Encore! XP
®
F6482 Series Development Kit
User Manual
HyperTerminal Configuration
A communications program such as HyperTerminal can be used on Windows XP systems
to view messages from the F6482 Series Development Board. The following procedure
examines how to configure HyperTerminal for the Z8F6482 demonstration project.
The HyperTerminal application is not available in Windows Vista and Windows 7 systems. If
you are using either of these operating systems, consider using/installing different communica-
tion software such as Tera Term; see
Appendix C. Tera Term Configuration
1. Connect the RS-232 to 6-pin circuit adapter to J20 on the Development Board. Con-
nect a 9-pin serial cable or USB-to-serial cable to the RS-232-to-6-pin adapter, then
connect the other end to your PC.
2. In HyperTerminal, choose
File Properties
then, if your PC has a serial interface,
select the COM port assigned to your serial port. If you do not have a serial port on
your PC, use a USB-to-serial adapter (not included in the kit).
Figure 11. Console Output Using Tera Term (Windows 7)
Note: