Figure 8, Select z8f64820100zcog and usb smartcable – Zilog Z8F1681 User Manual
Page 20
The Z8 Encore! XP
®
F6482 Series Development Kit
UM026301-1013
10
Z8 Encore! XP
®
F6482 Series Development Kit
User Manual
4. From the
Build
menu, select
Set Active Configuration
to open the Select Configura-
tion dialog box.
5. Select
Debug
, then click
OK
to close the Select Configuration dialog box.
6. From the Project menu in ZDS II, select
Settings
to open the Project Settings dialog
box. In the Project Settings dialog box, click the
Debugger
tab.
7. On the Debugger page, select
Z8F64820100ZCOG
from the Target list, then select
USB SmartCable
from the Debug Tool drop-down menu, as shown in Figure 8.
8. Click
OK
to close the Project Settings dialog box.
9. If you are prompted to rebuild any affected files, click
Yes
. Otherwise, choose
Build
from the menu bar, then click
Rebuild All
.
10. To run the application, select
Go
from the Debug menu, as indicated in Figure 9. As a
result, LEDs D4, D5, and D6 will blink in sequence.
Figure 8. Select Z8F64820100ZCOG and USB SmartCable