Z8051 ocd driver installation, Figure 5, Install device driver dialog, windows 7 – Zilog Z51F6412 User Manual

Page 14

UM025901-1112

Install the Z8051 OCD Software and Documentation

Z51F6412 Development Kit

User Manual

Z8051 OCD Driver Installation

The driver programs for the Z8051 On-Chip Debugger are copied during the software and
documentation installation. In the following procedure for PCs running the Windows 7 32-
and 64-bit operating systems, ensure that the target side of the OCD will remain uncon-
nected while you install these drivers.

If you are running Windows Vista, see

Appendix A

on page 39 to install your device driv-

ers. If you are running Windows XP, see

Appendix B

on page 42.

1. Connect the OCD hardware to the USB port of your PC by connecting the A (male)

end of one of the two USB A (male)-to-Mini-B cables with the host PC’s USB port.
Connect the Mini-B end to the OCD device.

2. After the PC detects the new hardware, it will display the Installing device driver soft-

ware dialog shown in Figure 5.

Figure 5. Install Device Driver Dialog, Windows 7

IMPORTANT NOTE: