Rear panel connections to the hda800(v2), Back panel connections defined, Overview – Zektor Palladia™ 8X8 User Manual
Page 9
HDA800(V2) User Guide, Version 1.3, 9/12/13
9
Overview
Rear Panel Connections to the HDA800(V2)
Back panel connections defined
IN-1 through IN-8 -- HDMI inputs.
OUT-1 through OUT-8:
•
IR-IN -- These inputs are used to send IR to the HDBaseT receivers. An IR controller can plug
directly into these inputs. They are a mono-jacks, polarity insensitive (it doesn’t matter how
you connect the two wires to the tip and sleeve of the connector), and they accept any voltage
between 3.5V and 15V.
•
IR-OUT These outputs are the return IR channels from the HDBaseT. They will drive a con-
troller or a standard 5V IR emitter/flasher. They use a mono jack, the sleeve is ground and the
tip is +5V when on.
•
HDBaseT -- These are the HDBaseT outputs and will drive up to 330ft of Cat5/6 cable to the
HDBaseT receivers. Power is also sent over the Cat5/6 cable and the HDBaseT receiver does
not need a separate power supply.
•
Local Out -- These are local HDMI outputs. They are not mirrored outputs, plugging in an
HDMI monitor to one of these outputs will disable the HDBaseT receiver.
•
RS-232 -- These allow two way RS-232 signals to be sent to the HDBaseT receiver. These are
straight through connections. They are the same pinout as the main RS-232 control port (See:
“RS-232 Pinout and Baudrate Settings” on page 28). The baudrates can be up to 115K.
•
Ethernet -- Each HDBaseT can have an Ethernet channel sent to it. These are 100Mbs full
duplex channels. There are no internal connections between the outputs, to send the Ethernet
down all 8 zones, you will need some type of 8 port Ethernet switch.
Analog Audio Inputs -- Left / Right stereo inputs.
Analog Audio Outputs -- Left / Right stereo outputs.
SW
-1
DB-1 DB-1 V+ V+ DB-2
SW
-2
DB-2
MODEL: HDA-800V2
1
3
5
7
2
4
6
8
1
3
5
7
2
4
6
R
L
8
1
3
5
7
2
4
6
8
1
3
5
7
2
4
6
8
1
3
5
7
2
4
6
8
AUDIO INPUTS - 9
SPDIF
SPDIF OUTPUTS
SPDIF INPUTS
ANALOG AUDIO INPUTS
ANALOG AUDIO OUTPUTS
OUT-1
IN-1
IN-2
IN-3
IN-4
IN-5
IN-6
IN-7
IN-8
OUT-2
OUT-3
OUT-4
OUT-5
OUT-6
OUT-7
OUT-8
WWW.ZEKTOR.COM
SAN DIEGO, CA
MADE IN USA
~110-230V
1.7A MAX
50-60 Hz
RS-232
RS-232
TCP/IP
IR
IR IN
IR OUT
HDBaseT
Local Out
Ethernet