Digi Counting Version 4.0 DC-190 - Manual (Page 27)

Scale Programming 33
Re-Computing Item Code Unit Weight
1. Recall item code from memory (see Section or Section ).
2. Place items to be counted on the scale.
3. Press the PIECES key for recomputing the unit weight.
4. Press the UNIT WEIGHT key to store the new unit weight into memory.
Set New Item Code with Tare and Unit Weight
NOTE: This can only be conducted if SPEC 4, bit 3 is 0 (Yes).
1. Enter the item code using the numeric keypad or Teraoka Code (see Section , Step 2).
2. If the code is not currently stored in memory and SPEC 19, bit 3 is 0 (Yes), the QUANTITY display shows
the message not F . If a new item code does not need to be stored into memory, press the CLEAR key to
exit to the normal mode. Otherwise, continue by pressing the CODE key. This will set the new item code
number into memory.
3. If the code is not currently stored in memory and SPEC 19, bit 3 is 1 (No), the QUANTITY display does
not show the not F message to alert you that the item code is not stored. Press the CODE key to set the
new item code number into memory.
4. Enter tare weight and press the TARE key. Press the TARE key again to store the tare weight into the item
code memory.
5. Place sample on the scale and press the PIECES key or use the numeric keypad to enter known weight
value (see Section 6.4 on page 27). Press the UNIT WEIGHT key a second time to store the weight value
into the item code memory.
7.3.1 Inventory Operations Related to the Item Code Quantity Value
The following procedure is used to add inventory to and remove inventory from an item code memory.
NOTE: The IN and OUT functions allow you to maintain the inventory (quantity) of a specific item in memory. Pressing the
CODE key while in the normal mode enables the IN and OUT annunciators.
If neither annunciator is illuminated, press the CODE key once to turn the IN annunciator on. Press the CODE key again to turn
the OUT annunciator on; press the CODE key a third time to turn both annunciators off.
To Add Inventory to an Item Code Memory–IN Mode
1. Press the CODE key one time. The IN annunciator illuminates.
2. Recall the item code from memory.
3. Place the container of parts to add to memory on the scale platter.
4. Press the * key to add the quantity shown on the display to the amount already stored under the item code
memory.
To Remove Inventory to an Item Code Memory–OUT Mode
1. Press the CODE key two times. The OUT annunciator illuminates.
2. Recall the item code from memory.
3. Place the container of parts to remove from memory on the scale platter.
4. Press the * key to remove the quantity shown on the display to the amount already stored under the item
code memory.
NOTE: If at any time you would like to verify the quantity of parts under a specific item code, you can press the
NET/GROSS key and the inventory amount will be displayed in the UNIT-WEIGHT display. However, you must
have SPEC 2, bit 0 (Inventory Display by Gross Key) set to 1 (Yes).