Xtramus MCM-W V1.3 - Manual (Page 39)

3.3.2. MCM-W HyperTerminal Commands
After logging in MCM-W via HyperTerminal, a MCM-W Command Menu will be displayed, showing
MCM-W’s HyperTerminal commands. Please see the table down below for brief descriptions of MCM-W
commands:
Command Alias Command Description
system sys
The system command allows you to view MCM-W’s system information, make
system configurations, and upgrade MCM-W’s firmware/FPGA.
counter cnt The counter command allows you to view MCM-W’s counter information.
ip ip
The ip command allows you to view MCM-W’s current IP settings or configure
these settings.
ddmi ddmi
The ddmi command allows you to view the Digital Diagnostics Monitoring
Interface.
LLF llf
The LLF command allows you to enable/disable the Loss Link Forwarding
function.
cls cls The cls command allows you to clear HyperTerminal screen.
logout logout
The logout command allows you to log out. For security issues, it is
recommended that you should log out if you’re not using the HyperTerminal
anymore.
Please see sections down below for more detailed information regarding to MCM-W’s command.
39
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®