WaveWare Repeater - Manual (Page 9)

TRANSMITTER PROGRAMMING SOFTWARE
Repeater Programming
July 16, 2009 7
REPEATER
Repeater Programming
Introduction
Please follow the below steps for programming Repeater ：
1. Connect Repeater to a PC
2. Identify the COM Port that is being connected to.
♦
If you are using a Serial Port as your connection to the PC, please make sure it is
connected to COM1 or COM2.
♦
If you are using a USB-to-Serial connection and have installed the driver for
USB-to-Serial connection, the 「 Prolific USB-to-Serial Comm Port 」 will appear
under Ports (COM&LPT). The following screen gives an example of the systems
detects a USB-to-Serial connection is being connected to COM3. It appears
Prolific USB-to-Serial Comm Port (COM3).
♦
If 「 Prolific USB-to-Serial Comm Port 」 does not appear, please refer to the
instruction for installation on USB connection.