WaveWare Repeater - Manual (Page 14)

TRANSMITTER PROGRAMMING SOFTWARE
Repeater Programming
July 16, 2009 12
REPEATER
File | Save As
Save the current code-plug data to a file with different filename. If you saved the
code-plug data file previously and don’t need to change the file name, you can used
the Save command instead.
Program | Write
Write the current code-plug data to the REPEATER.
Program | Read
Read code-plug data from the REPEATER.
About
Information about the REPEATER programming version.
Serial Setting
COM Port
After the program is executed, the system will automatically load the available COM
Port into the menu and set COM1 as the primary COM Port.
Link
Press "Link" to wait for the connection between REPEATER and PC.
Reset
Note that all the changes will only be effected after the REPEATER is being reset. To
rest REPEATER, press “Reset” after it is successfully programmed.
Frequency
Ranger Of Frequency
Select your desired frequency range.
.