S_rssi setting – WaveWare Repeater User Manual
Page 8

TRANSMITTER PROGRAMMING SOFTWARE
S_RSSI Setting
July 16, 2009
6
REPEATER
S_RSSI Setting
Please make sure to configure the S_RSSI setting before programming your repeater.
After turning on the repeater, connect the RS-232 cable to your PC. Please be sure to run
the program "Read Repeater RSSI" within 3 minutes. After you requested number of times
for reading, you’ll get the average offset value of the repeater.
For example, you put “50” in Read RSSI(s), then the software will read the RSSI value for 50
times and get the average offset value. If the average offset value is 76, then add 10. The
S_RSSI value for programming will be 86.