WaveWare Repeater User Manual
Page 16
TRANSMITTER PROGRAMMING SOFTWARE
Repeater Programming
July 16, 2009
14
REPEATER
Blocking Address
Addr #1
You can block the repeating of signals for up to 12 capcodes.
Upper / Lower Limit Address
The signals will only repeat for the capcodes within this range.
Command Address
To set the layer for Multi-layer repeating.
Delay
Delay #1
To set the time delay for repeating after receiving a signal. The unit is based on
250ms. For example, if you would like to delay the repeating for 1 second, then
enter “4”.