Vectronics VEC-121K User Manual

Page 20

VEC-121K Owner's Manual

Crystal Radio Set Kit

Only a few more steps remain, and the set will be finished.

Refer to the drawing below for the last wiring steps.

DET2

EAR1

! Cut a 4½” length of 18 AWG enamel wire from the wire spool in the kit.

! Remove 1” of insulation from each end.

! Form each end of the wire into an end connection.

! Loosen the screws mounting the Fahnstock clips DET2 and EAR1.

! Take one of the wire end connections and place between the DET2 clip and

breadboard.

! Tighten the mounting screw for the DET2 clip until snug.

! The remaining end connection is placed between the EAR1 clip and

breadboard.

! Tighten the mounting screw for clip EAR1 until snug.