Vectronics VEC-830K User Manual
Page 11
VEC-830K Instruction Manual
Single Side-Band Filter Kit
21.
Locate capacitor C4
(1000pF).
This is another polystyrene capacitor
and will be marked
"1000J"
(actual value in
pF).
Carefully install
C4
in
the same manner as
C3,
solder in place, and trim the leads.
22.
Locate capacitor C5
(1000pF).
This is another polystyrene capacitor
and will be marked
"1000J"
(actual value in
pF).
Carefully install C5 in
the same manner as
C4,
solder in place, and trim the leads.
23.
Locate capacitor C6
(470pF).
This is a polystyrene capacitor and will
be marked
"470J"
(actual value in
pF).
Carefully install C6 in the same
manner as C5, solder in place, and trim the leads.
24.
Locate capacitor
C7 (470pF).
This is a polystyrene capacitor and will
be marked
"470J"
(actual value in
pF).
Carefully install
C7
in the same
manner as C6, solder in place, and trim the leads.
25. Locate capacitor
C8 (470pF).
This is a polystyrene capacitor and will
be marked
"470J"
(actual value in
pF).
Carefully install C8 in the same
manner as
C7,
solder in place, and trim the leads.
26. Locate two (2) 6" insulated wires. Cut these wires in halt, making
four (4)
3"
pieces.
27.
Using the wire strippers, remove the about
1/4" of
the insulation
from the insulated ends of each
3"
piece of insulated wire.
28.
Locate Point #1 on the circuit board. Insert one of the
3"
wires into
the hole at Point #1 on the circuit board. Solder in place and trim the
lead.
29.
Locate Point #2 on the circuit board.
Insert one of the
3"
wires
into the hole at Point #2 on the circuit board. Solder in place and trim
the lead.
30.
Locate Point #3 on the circuit board.
Insert one of the
3"
wires
into the hole at Point #3 on the circuit board. Solder in place and
trim the lead.
31.
Locate Point #4 on the circuit board.
Insert one of the 3" wires into
the hole at Point #4 on the circuit board. Solder in place and trim the
lead.
32.
Locate one (1) 6" insulated wire. Cut this wire in half, making two
(2)
3"
pieces.
33.
Using the wire strippers, remove the about
1/4" of
the insulation
from the insulated ends
of
each
3"
piece
of
insulated wire.
1