TVLogic LVM-091W-M - Manual (Page 9)

Name & Function of Each Part
Mu
lti F
orma
t L
CD Monit
or
09
[PHASE] Button/Lamp
- Used to change the Phase value. Press [PHASE] button and use [UP]/[DOWN] button to control.
#Phase is not available in DVI Analog & PAL mode.
[WAVEFORM]/[VECTOR SCOPE] Button/Lamp (Refer to page 19-20)
- [Wave Form YCbCr] : Displays each waveform for elements of the luminance and Cb/Cr of the
input signal.
- [Wave & Vector] : Displays waveform and vector scope simultaneously.
- [Vector YCbCr] : Displays Vector scope and Y/Cb/Cr waveform simultaneously.
* See section “Other Functions [6]Wave Form function and [7]Line Select” for more information.
[MENU] Button
- Used to activate the main OSD Menu.
[UP] Button
- Used to move within the menus during OSD menu activation and is also used to increase the
value of selected feature.
- In Pixel to Pixel mode, press the button to rotate the display clockwise.
[DOWN] Button
- Used to move within the menus during OSD menu activation and is also used to decrease the
value of the selected feature.
- in Pixel to Pixel mode, press the button to rotate the displays counterclockwise.
[ENTER] Button
[POWER] Switch
[TALLY] Lamp
- Tally lamp that can be toggled in green or red using the REMOTE(RJ-45) port or RS-422 serial
communication.
[APERTURE] Knob
- Used to adjust the picture sharpness. The value is selectable between -12 ~ 12.
#Aperture is not available in DVI Analog or Graphic mode.
[BRIGHT] Knob
- Used to adjust the degree of brightness.
- The value is selectable between -128 ~ 127.
[CHROMA] Knob
- Used to adjust the saturation of the image.
- The value is selectable between -128 ~ 127.
# This feature is not available in DVI Graphic mode and DVI Analog.