beautypg.com

Name & function of each part – TVLogic LVM-091W-M User Manual

Page 8

background image

Name & Function of Each Part

M

ul

ti F

orm

at

L

CD M

oni

to

r

08

[ANALOG] Button/Lamp

- Used to select desired Analog input. (CVB1/2/3, S-Video, Component, RGB)
- Press the button to activate the analog input menu-selection, then use UP and DOWN button to
select desired input.
* See section “Other Functions [1]ANALOG Button” for more information.

[DVI] Button/Lamp

- Used to select desired DVI input.
- Press the button to activate the DVI input menu selection, then use UP and DOWN button to
select desired input.
* See section “Other Functions [2]DVI Button” for more information.

[SDI-A]/[SDI-B] Button/Lamp

- Used to select SDI-A/SDI-B input.

[SCAN] Button/Lamp

- Used to change the scan mode.
- Press the button to activate through the scan modes: [UNDERSCAN] -> [OVERSCAN] -> [PIXEL TO
PIXEL] -> [USER ASPECT] -> [UNDERSCAN]
#PIXEL TO PIXEL mode is not available in graphic mode.
#[USER ASPECT]: User can adjust width and height of the display.
* See section “Other Functions [4] Pixel to Pixel and [5] User Aspect” for more information.

[ASPECT] Button/Lamp

- Used to change the display ratio between 4:3 and 16:9.
* Display ratio locks to 16:9 if the display ratio of input signal is 16:9.

[MARKER], [HVDELAY] Button/Lamp(LVM-091W)

- Used to activate/deactivate the Marker. The type of marker at work may be selected on the main
menu.
- Used to check horizontal sync and vertical sync simultaneously.

[BLUE ONLY]/[MONO] Button/Lamp

- Press the button to remove red and green from the input signal and display the screen only
under a blue signal. Press the button again to activate mono mode.
They are not available in RGB, DVI ANALOG, DVI DIGITAL and HDMI modes.
# [Focus Assist] : Focus assist support feature.
Use [Up]/[Down] button to control the sensitivity level(0~80) of Focus Assist. Maximum value is 80.